Primer on Flat Rolling

Передня обкладинка
Newnes, 4 груд. 2013 р. - 450 стор.

Primer on Flat Rolling is a fully revised second edition, and the outcome of over three decades of involvement with the rolling process. It is based on the author's yearly set of lectures, delivered to engineers and technologists working in the rolling metal industry. The essential and basic ideas involved in designing and analysis of the rolling process are presented.

The book discusses and illustrates in detail the three components of flat rolling: the mill, the rolled metal, and their interface. New processes are also covered; flexible rolling and accumulative roll-bonding. The last chapter contains problems, with solutions that illustrate the complexities of flat rolling.

New chapters include a study of hot rolling of aluminum, contributed by Prof. M. Wells; advanced applications of the finite element method, by Dr. Yuli Liu and by Dr. G. Krallics; roll design by Dr. J. B. Tiley and the history of the development of hot rolling mills, written by Mr. D. R. Adair and E. B. Intong.

Engineers, technologists and students can all use this book to aid their planning and analysis of flat rolling processes.

  • Provides clear descriptions for engineers and technologists working in steel mills
  • Evaluates the predictive capabilities of mathematical models
  • Assignments and their solutions are included within the text
 

Вибрані сторінки

Зміст

1 Introduction
1
2 History of Hot Strip Mills
17
3 Roll Design
31
4 Flat Rolling A General Discussion
39
5 Mathematical and Physical Modelling of the Flat Rolling Process
57
6 An Advanced Finite Element Model of the Flat Cold Rolling Process
113
7 Flat Rolling Simulation and Reduction of Local Buckles in Cold Rolling
125
8 Material Attributes
163
11 Hot Rolling of Aluminium
279
12 Temper Rolling
291
13 Severe Plastic Deformation Accumulative Roll Bonding
303
14 Roll Bonding
323
15 Flexible Rolling
337
16 Problems and Solutions
349
Appendix
379
References
387

9 Tribology
193
10 Applications and Sensitivity Studies
267
Авторські права

Інші видання - Показати все

Primer on Flat Rolling
John G. Lenard
Обмежений попередній перегляд - 2007
Primer on Flat Rolling
John G. Lenard
Перегляд фрагмента - 2007
Primer on Flat Rolling
John G. Lenard
Попередній перегляд недоступний - 2017
Показати все »

Загальні терміни та фрази

1D model adhesion aluminium alloy asperities austenite buckles calculated coefficient of friction coil box cold rolling compression determined diameter dynamic recrystallization elastic emulsion entry temperature entry thickness equation exit finishing mill flat rolling process flattening flow strength forward slip friction factor grain heat transfer coefficient hexit hot rolling hot strip mills increasing indicates interfacial layer Lenard lubricant magnitude material mathematical models measured mechanical metallurgical microstructure mm/s MTPY obtained parameters plastic deformation predictions ratio reduction resistance to deformation ridge roll force roll gap roll pressure roll separating force roll surface roll torque rolled metal rolled strip rolling mill rolling passes rolling speed sample scale shear strength shear stress short tons shown in Figure slab Stand 1 Stand strain rate strip thickness surface roughness temper rolling tensile tion Tribology true stressÀtrue strain velocity viscosity width yield strength yield stress zone

Бібліографічна інформація

НазваPrimer on Flat Rolling
Elsevier insights
АвторJohn G. Lenard
Видання2, виправлене
ВидавецьNewnes, 2013
ISBN0080994121, 9780080994123
Обсяг450 стор.
  
Експортувати бібліографічний описBiBTeX EndNote RefMan