Зображення сторінки
PDF

ble cut-out for each outlet, protecting both
sides of the circuit.

| \,. This contractor shall attach — sockets by

o, means of a (suitable gas attachment) to the

Alon (gas) fixtures already in place. These fixtures - , shall be properly insulated, and shall be wired, in the following manner: —— -— , with • *- o At each outlet a suitable cut-out shall be provided, protecting both sides of the circuit. In each socket shall be placed the proper lamp,

and all shades shall be attached.

*...* Sockets and lamps shall be suspended by

*"o" means of — pendants from the ceiling. Each pendant to be —— in length (provided with a cord adjuster) and protected by a double-pole ceiling cut-out. Both at the cutout and in the socket the cord shall be knotted so that in no case will the weight come on the binding screws. Where the cord passes through the neck of the socket it shall be pro

. . . . tected by a -— bushing. In each socket shall

be placed the proper lamp, and all shades

shall be attached.

Three-Wire System.

This specification is identical with the twowire specification, except in “System,” p. 77, sec. 84, in place of which insert the following:

feeders on the basis of the three-wire system, but the distribution circuits shall consist of two wires

All }}. ! and mains shall be figured

only except to outlets for a group of —, ,

— c. p., lamps or more, and for special circuits specifically mentioned. Care shall be taken in arranging the distribution circuits to have the same number of lan)ps on each side

a 106. System.

[ocr errors]

of the system, and that no circuit shall be .

connected across the outside wires. The neutral wire shall in all cases be properly tagged and shall be run between the outside wires.

J.
Three - Wire System Adapted to the Two - Wire
System.

This specification is identical with the twowire specification, except in “System,” p. 77, sec. 84, in place of which insert the following:

All }}.} and mains shall consist of

three wires, but the neutral wire shall consist of two wires, each equal in cross-section to the outside wires, or of one wire equal in cross-section to the outside wires combined, in order that if desired all lights may be operated on the two-wire system; if two neutral wires are run they shall be permanently connected at each cut-out box. All distribution circuits shall consist of two wires only except to outlets for a group of , -—C. p.,

[ocr errors]

- - --

107. System.

lamps or more, and for special circuits specifically mentioned. In all three-wire distribution circuits the neutral shall be equal in cross-section to the two outside wires combined. Care shall be taken in arranging the distribution circuits to have the same number of lamps on each side of the system and that no circuit shall be connected across the outside wires or between the neutral wires. The neutral shall in all cases be properly tagged and shall be run between the outside wires.

Arc System.

108. Circuits. The lights shall be divided into the following circuits: Circuit No. 1 (Number of lights and location.) 4% NO. 2 ( << << 44 ), etc.

... 'W'. All wire used in the installation shall be

10 ‘e. . - * - - - -

insulated with — for inside circuits, and with — for outside circuits.

110. Insula. Each circuit shall test out with an insulation Resist

all Ce. tion resistance of at least — ohms. 111. Joints. See p. 80, sec. 92.

112. Method All interior wires shall be run

of Wiring. -
| on insulators

in conduits o in such a manner that the

highest possible insulation is obtained. All
wiring shall be neat in its mechanical appear-
ance and arrangement. All exterior wires
shall be run —. - - - - -
In the interior of (the) building(s) the lamps
specified shall be suspended from —securely
fastened to the ceiling (and provided with a
suitable device for raising and lowering). On
the exterior of (the) building(s) the lamps
specified shall be suspended from —, securely
attached to ——, (and provided with a suita-
ble device for raising and lowering).
(Add details concerning any posts, pole-
steps, ornamental treatment desired, etc.)

Conduit System. Two-Wire.

No wires shall be run in contact with any part of the building material, but the building shall be equipped from the source of supply to each outlet with the insulating conduits of — in such manner as to provide continuous channels or raceways for the wires. The continuity of each tube employed for this purpose shall be such as would be required if it were to be used for conveying water or gas. Strict compliance with this requirement will be demanded.

In order that every wire may be at all times accessible for inspection, repairs, or renewals

[merged small][ocr errors][merged small]

115. Accessi bility.

without injury to the building, the location, sectional division, joining, intermediate and terminal elbowing, the placing of switches, cut-outs, and junction boxes, and the final emergence of the tube beyond the finished surface at the fixture outlet shall be done in strict compliance with this specification.

116. Appli. All appliances employed shall be such as all CeS. - - • • are especially adapted for use in conjunction with the conduit system.

[merged small][ocr errors][merged small][merged small][ocr errors][merged small][merged small][ocr errors][merged small][ocr errors][merged small][merged small]

lo" (See p. 77, sec. 85.)

*...* All single conductors shall be insulated with ——. All duplex conductors shall be insulated with ––. Duplex conductors and all single conductors larger than — a

| ; & a | shall be stranded,

w

[ocr errors]
« НазадПродовжити »