Відгуки відвідувачів - Написати рецензію
Не знайдено жодних рецензій.
Інші видання - Показати все
acid action alternate amount amperes angle armature arranged attracted ball battery become bismuth body called capacity carbon cause cell centimetres charge chemical circuit coil conducting conductor connected consists copper direction discharge disk distance earth effect electricity electrified electromagnet electromotive-force energy equal experiment explained field flow force galvanometer give given glass greater heat Hence increase induction influence insulated internal iron joined kind known lamp length less Lesson light lines liquid machine magnetic means measure metal method motor move needle negative observed ohms opposite pass piece placed plate polarization pole positive potential produced proportional quantity receiver repelled represent resistance rotation round separate shown shows side solution spark sphere square strength substances Suppose surface tend thin touched tube turns unit usually volts wire zinc
Сторінка 584 - As a umt of resistance, the international ohm, which is based upon the ohm equal to 109 units of resistance of the Centimetre-Gramme-Sevond system of electromagnetic units, and is represented by the resistance offered to an unvarying electric current by a column of mercury at the temperature of melting ice 14'4521 grammes in mass, of a constant cross-sectional area and of the length of 100-3 centimetres.
Сторінка 586 - As a unit of work, the joule, which is equal to 107 units of work in the CGS system, and which is represented sufficiently well for practical use by the energy expended in one second by an international ampere in an international ohm. As a unit of power, the watt, which is equal to 10...
Сторінка 637 - The Electrical Researches of the Honourable Henry Cavendish, FRS Written between 1771 and 1781, Edited from the original manuscripts in the possession of the Duke of Devonshire, KG, by J. CLERK MAXWELL, FRS Demy 8vo. cloth, iSs. Hydrodynamics, a Treatise on the Mathematical Theory of Fluid Motion, by HORACE LAMB, MA, Professor of Mathematics in the University of Adelaide.
Сторінка 589 - ... above the cork, using sufficient to cover completely the zinc and soldering. The glass tube containing the platinum wire should project some way above the top of the marine glue. The cell may be sealed in a more permanent manner by coating the marine glue, when it is set, with a solution of sodium silicate, and leaving it to harden.
Сторінка 585 - The unit of quantity shall be what is known as the international coulomb, which is the quantity of electricity transferred by a current of one international ampere in one second. Fifth. The unit of capacity shall be what is known as the international farad, which is the capacity of a condenser charged to a potential of one international volt by one international coulomb of electricity.
Сторінка 588 - ... temperature, agitating it from time to time, then allow it to cool ; continue to shake it occasionally while it is cooling. Crystals of zinc sulphate should then be distinctly visible, and should be distributed throughout the mass ; if this is not the case, add more crystals from the stock bottle, and repeat the whole process. This method ensures the formation of a saturated solution of zinc and mercurous sulphates in water. To set up the Cell. The cell may conveniently be set up in a small test...
Сторінка 585 - The unit of current shall be what is known as the international ampere, which is onetenth of the unit of current of the centimeter-gramsecond system of electro-magnetic units, and is the practical equivalent of the unvarying current, which, when passed through a solution of nitrate of silver in water...
Сторінка 585 - As a unit of electromotive force, the international volt, which is the electromotive force that, steadily applied to a conductor whose resistance is one international ohm, will produce a current of one international ampere, and which is represented sufficiently well for practical use by ^2.
Сторінка 588 - C. Keep the paste for an hour at this temperature, agitating it from time to time, then allow it to cool ; continue to shake it occasionally while it is cooling. Crystals of zinc sulphate should then be distinctly visible, and should be distributed...