Зображення сторінки
PDF
ePub

34. Foundation(s).

power of the lamps; and that when two or more are operating on the same circuit the load may be divided between them in proportion to their respective capacities under all conditions from no load to full load; if of the alternate current, constant-current or

stant-potential type,

[ocr errors]

{they} shall be guaran.

teed as efficient in their operation as any

of the direct-current types.

The dynamo(s) shall be rated with such margin of safety that they will not be in

it

jured if subjected to a temporary overload of per cent. above such rating.

(See Note: p. 44., sec. 22.)

The foundation(s) for the (se) dynamo(s)

[merged small][merged small][merged small][merged small][ocr errors]

laid, or of other material subject to the

[ocr errors]

approval of the engineer,
architect, and shall be of
} S

sufficient length, width, and depth to safely
their
and firmly sustain its weight. The
foundation(s) shall be capped with a framing
of well seasoned timber securely fastened
thereto, the dynamo base-frame (s) being se-
curely fastened to the framing or to the foun-
dation through the framing, both framing and
baseframe being secured in such a manner as
to prevent lateral motion in either direction.

and to give an even bearing surface at every point. If metal is used to fasten framing or baseframe to the foundation it must be thoroughly insulated where it passes through them, and at all places liable to come in contact with the dynamo must be countersunk and covered with a moisture-proof insulating compound.

All necessary excavating and filling, and the removal of all débris shall be done by the contractor. The height of the dynamo purchaser. S baseframe(s) above the ground will be

(See Note: p. 45, sec. 23.)

There shall be provided with each dynamo one voltmeter or pressure indicator which shall remain constantly in circuit so as to indicate at all times the pressure at the point to which it is connected; one brush jig for trimming the brushes; one insulating baseframe provided with rails and a suitable device for shifting the position of the dynamo to alter the belt tension; if of the constant potential type, one hand regulator made. entirely of incombustible material, a headboard switch for cutting off the current at the dynamo, a compensator or suitable balancing device for keeping the current in each circuit practically constant; if of the constant current type an automatic regulator for so controlling the potential as lights are turned on or off that the current shall not vary appre

35. Instru

ments.

36. Cables to Switchboard.

37. Starting Plant and Instruction.

38. Renewal Parts.

ciably from its normal value under any condition of load. There shall be provided for each circuit one ampère meter for indicating the current in said circuit, one ground detector which shall continuously indicate the insulation from the ground maintained at both poles and approximately the distance of any ground from the station, and one pair of efficient lighting arresters. There shall also be provided one testing magneto capable of ringing through ohms.

This contractor shall carry to the switchboard location at all regulator, exciter, auxiliary, and main wires, leaving the ends coiled up neatly, properly tagged and sufficiently long to make the necessary switchboard connections. All main wires shall have a capacity of at least

and no wire smaller than
B. W. G. shall be used.
insulated with

C. M. per ampère
B. & S. or

All wires shall be ; shall be run ; when of opposite polarity shall be separated at least --; and where crossing each other, wires of other circuits, or passing near metal pipes, girders, etc., shall be further protected by In no case shall insulated wires be carried in such proximity to heated surfaces, vapors, or air as to endanger their insulation.

(See p. 46, sec. 25.)

(See p. 47, sec. 26.)

(See Note: p. 47, sec. 27.)

Each bidder shall fill out completely the

following summary:

Number of dynamos

Trade number or designation

Rating in volts at maximum load

Rating in ampères at maximum load
Direct or alternating current

Constant or varying current
Constant or varying potential

Series, shunt, compound, self or sepa

rately excited

Rating of exciter in volts

Rating of exciter in ampères

Trade number or designation

Regulation by hand or automatic
Number of fully loaded circuits possi-
ble to operate per dynamo

Make of lamp recommended for use
Number of c. p. lamps of above
make per circuit
C.
c. p. lamp

Volts per

Ampères per — c. p. lamp

H. P. required to be delivered at the pulley at full load with no loss in the feeders but including exciter

(See p. 48, sec. 28.)

39. Summary.

40. Switch

board.

board Appar

atus and Con

There shall be placed upon this switch-41. Switchboard, in addition to all the dynamo regulating apparatus, such switches, cut-outs, and other appliances as are necessary for the

nections.

42. Circuits.

proper and convenient manipulation of the circuits, such appliances to be named by each bidder in his proposal. For systems operating dynamos and circuits in parallel, the appliances and connections shall be such as will permit adding to or taking from the circuit any dynamo without in any manner affecting the operation of the remaining dynamos in circuit or the candle power of the lamps, and will permit the cutting in or out of any circuit without affecting the stability of other circuits. For systems operating one dynamo for each circuit or series of circuits the connections shall be such as will permit any circuit to be connected to or disconnected from any dynamo with certainty and rapidity. (For switchboard connections see secs. 30 and 31, p. 50).

(See p. 51, sec. 32.)

43. Dynamo(s).

Constant Potential, Alternating Current
System.

This contractor shall furnish, and, unless otherwise specified, erect the following apparatus and material:

constant potential, alternating current dynamo(s) (each) having a capacity of

c. p.,

volt incandescent lamps.

« НазадПродовжити »